Slicer Discord
Simple Projector 3 Axis Mount (RPJ280) – 3D-printbaar model van Thingiverse Thingiverse

Simple Projector 3 Axis Mount (RPJ280)

door RawDR
0 Downloads
0 Likes
0 Makes
Model downloaden
This is an adjustable mount for a projector, in my case the RCA RPJ280, with an M6 threaded mount. Three M3 screws are used to adjust/tilt the projector in the XY axes and the mount itself can swivel before you tighten it down for the 3rd axis.

The screw feet simply screw/push onto the M3 screws to steady them against the projector and avoid marring the plastic.

IMPORTANT: There's a cavity in each of the three small holes for an M3 nut to be embedded in the print. These hold each M3 screw. Set your slicer to automatically pause print at the last layer before the cavity is bridged over, and place the M3 nut in the hole. Then continue the print and it will seal them in place.
Bron
Thingiverse
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

RawDR publiceert ook op

14 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie