Thingiverse
Simple PTFE Coupler
von maa_boo
6
Downloads
3
Likes
0
Makes
Yet another coupler for PTFE (Bowden) tube, but from Junk-Tec engineers. No threads, no screws, just friction and power of your hands.
Print it on the smooth surface.
For friction adjustment use extrusion multiplier.
ATTENTION: this coupler creates 1 mm gap between connected tubes, but it shouldn't be a problem.
Print it on the smooth surface.
For friction adjustment use extrusion multiplier.
ATTENTION: this coupler creates 1 mm gap between connected tubes, but it shouldn't be a problem.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!