Thingiverse
Simple Raspberry Pi Zero 2 W mount for Ender 3
door Kaint
30
Downloads
16
Likes
0
Makes
Just a simple mount for my Raspberry Pi Zero 2 W on my Ender 3 Pro!
It fit under the screen by sliding the case on the v-slots extrusion. The case fits nicely and does not need hardware to be held in place.
However, the case is 2 parts to allow easier maintenance, so you'll need 2 screws. Mine were old screws I had laying around, 8 * 3mm.
It has a hole to accommodate a little heatsink, and a bigger hole on the top for some gpio connection (for example like me, a relay).
No particular print settings needed.
Enjoy !
It fit under the screen by sliding the case on the v-slots extrusion. The case fits nicely and does not need hardware to be held in place.
However, the case is 2 parts to allow easier maintenance, so you'll need 2 screws. Mine were old screws I had laying around, 8 * 3mm.
It has a hole to accommodate a little heatsink, and a bigger hole on the top for some gpio connection (for example like me, a relay).
No particular print settings needed.
Enjoy !
Kaint publiceert ook op
4 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
