Simple razor and brush stand

A simple stand for double-edge razors and a brush. It's made of 3 parts which should be glued together with some epoxy or CA. You can also apply some coating to protect it from humidity if needed.PrintingUse a rigid plastic like PLA to avoid sagging over time. I would also suggest using 3-4 perimeters. Layer height should be no more than 0.2mm for 0.4mm nozzle or no more than 0.28mm for 0.6mm nozzle. Print 1 instance of each part.AssemblyBrush logo on the leg should look downwards and should be on the side of large brush hole. Razor logo should be on the side of small razor hole. Test fit before gluing. Apply a small amount of epoxy or CA to tenons and mortices, glue the parts together. Read your epoxy or glue manual for details on how to use them. If you want to apply some kind of protective varnish, apply it after your glue is completely cured.