Thingiverse
Simple RC Airplane Hinge
door Jimmers2222
46
Downloads
39
Likes
0
Makes
This is a simple hinge for control surfaces on an RC airplane. It's symmetrical, so 2 pieces make 1 hinge. A small paper clip, straightened, is used for the "pin" (see picture).
You may need to drill out the 1mm pin hole.
Inspired by Painless360's version, https://www.thingiverse.com/thing:1334035 but designed to use a single symmetrical model.
You may need to drill out the 1mm pin hole.
Inspired by Painless360's version, https://www.thingiverse.com/thing:1334035 but designed to use a single symmetrical model.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!