Thingiverse
Simple Sailboat
von wjallison1122
5
Downloads
3
Likes
0
Makes
I made a boat. I wanted to experiment with thin surfaces and vertical supports, and I think this is about as thin as the printer (a Prusa i3 MK3S) can reliably do.
The sail and boom were attached using a 3d pen. I nearly melted the mast off with the tiny glob of filament.
I may add a forward sail later on.
The sail and boom were attached using a 3d pen. I nearly melted the mast off with the tiny glob of filament.
I may add a forward sail later on.
wjallison1122 veröffentlicht auch auf
1 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
