Simple Snap CHAMP

This design for the CHAMP Clamp is printable in a single print, and requires no assembly. The ABS prototype of the Simple Snap CHAMP has been tested to exceed 200lbf of tensile loading and uses an efficient 2.39in^3 of material. Additionally, the clamp is held onto the Handrail quite tightly, and can not be twisted off or slid around once it's flaps are secured. For highest strength, the Simple Snap CHAMP is to be printed using .4mm extrusion widths, 6 perimeters, and solid fill. No support is required. For reference, my prototypes were printed on a Fablicator, with KISSlicer for G-code generation *Tensile test was done by doing a pull-up from a handrail suspended by the Simple Snap CHAMP. https://www.youtube.com/watch?v=auO_ZrkYWo0 The SolidWorks design file is also well-organized in the event any changes are desired in the future.