Simple Thuma Pillowboard Support

The pillow board for the Thuma bed needs to be flush with the wall, but this isn't always possible, in my case because of a radiator which is in the way. These parts print as a single piece (or in the case of the version with a pin, 2 pieces) and without supports, while also adding 4 inches of height the the pillow board. A version which doesn't add 4 inches of height is also included. The pieces slide onto the ends of the frame, but there is also a version with a pin allowing the piece to slot in from the back. I recommend printing 4 but more or less may suite your needs. I've designed these to use the minimum material while still being extraordinarily strong using finite element analysis. The strange shapes at the corners around the bed frame are not a mistake, but instead make the design stronger by eliminating right angles. Please reach out to me if you have any questions.

If you want to edit the design and make sense of my terrible CAD here you go:
https://cad.onshape.com/doc