simple Towel Holder / Rack

I designed this simple towel holder in order to have a seperate towel in the bathroom. It works perfectly fine and was designed using TinkerCad.

Printing:

- PLA filament was used
- Print speed was set to 50 mm/s
- printing time was roughly 55mins using AnyCubic i3 Mega-S Printer
- Activate Support for the overhang
- If needed, please rotate the model in your slicer so that the thick base is on the print bed
- Infill was set to 50%, although 60 / 70% would also be fine, especially for heavier towels
- I mounted the product on a rather flat wooden surface with some strong double sided tape.