Simple Turntable (Scalable)

My wife took a video of her turning her flower arrangement by hand and the noise of the vase vibrating against the table was enough motivation for me to modify my card lazy susan to work as a simple turn table. I tried out someone else's design first that used a 3D printed bearing, but that bearing was unreliable when my simple two piece snap joint worked almost as well with a fraction of the hassle. So ta da! SIZING:The turntable is 3 ¾" in diameter with the base being 3" in diameter. Overall the assembly is about ½" thick with about .04" clearance from the top piece to the surface it's sitting on. If you want a larger turntable, this should be scalable in just the X-Y so you can maintain a low profile and not use more material than necessary. ASSEMBLY TIP:The pieces can be a little tough to snap together so I suggest placing the bottom piece on a flat surface then press down on the center of the top. Don't be afraid to put some weight on it as it won't