SimpleHuman Triple Wall Pump Shelf

This is a shelf that replaces the three top caps of the SimpleHuman Triple Wall Pump for showers / baths.
Features:
Flared openings allowing for easy install / removal with tight tolerances around the top of each of the wall pump cylinders
Perpendicular support against the wall to which the Triple wall pump plate is mounted
Level grated surface with slightly angled underside to allow for drainage and drainage holes on back side of shelf
Small lip around exterior of shelf to prevent objects from slipping off

Print Tips:
This shelf is >256mm in length so slicing with a dovetail or printing at an angle would be required.
Use a filament with low base moisture absorption
If using ABS use >2 wall loops to ensure no gaps in print; alternative is to seal with silicon or epoxy