Thingiverse
Simpler Bambu Lab spool
von HerrN87
1
Downloads
0
Likes
0
Makes
I really like the locking mechanism on this spool but it took to long to print.
This design might be a lot uglier but it uses at least 35% less material and prints in about half the time.
The original is way prettier though!
So if that is what you´re looking for in a filament spool you should use the original.
This design might be a lot uglier but it uses at least 35% less material and prints in about half the time.
The original is way prettier though!
So if that is what you´re looking for in a filament spool you should use the original.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!