Thingiverse
Simplest Spool Holder
von HeavenGuy
1
Downloads
0
Likes
0
Makes
The original spool holder is not good enough. Therefore, I would like to design a spool holder that is easy to print, easy to assemble, and easy to use.
Nore:
1) A spool holder need 2 Bases and 3 Rollers.
2) 4 ball bearings are required-outer diameter 16 mm, inner diameter 8 mm, width 6mm.
Nore:
1) A spool holder need 2 Bases and 3 Rollers.
2) 4 ball bearings are required-outer diameter 16 mm, inner diameter 8 mm, width 6mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
