Thingiverse
Simplistic Dice Tower
von Johnreinker
12
Downloads
4
Likes
0
Makes
Block supports everywhere but the doorway
Print at 180mm+ on the Z height (uniform scaling) for large die
Print at 120mm+ on the Z height (uniform scaling) for mini die
Prints well with 15% cubic infill
Doesn't need to be printed any finer than .2mm layer height
Should not need any bed adhesion if your printer is dialed in (No brim, raft, etc.)
Print at 180mm+ on the Z height (uniform scaling) for large die
Print at 120mm+ on the Z height (uniform scaling) for mini die
Prints well with 15% cubic infill
Doesn't need to be printed any finer than .2mm layer height
Should not need any bed adhesion if your printer is dialed in (No brim, raft, etc.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!