Simpsons TV - For "VERSION B+" Screen

For those who recieved a screen which states it is "Version B+".

You can use this display and it will work ok, but you will need to make a note of the following changes:

- The GPIO18-PWM jumper that you will need to solder is in a different position, please refer to the images above.

- You must install the Raspberry Pi Zero W onto the middle row of GPIO pins, NOT the top row, (Please refer to the images above).

- Since the Raspberry Pi now must be installed higher than normal, you will need to use this updated STL model of the screen which provides a little more room for the power connection, NOTE: you will likely need to buy a right angle micro USB connector so it will fit wihtin the tight constraints. (Refer to the images for the right angle connector that is needed). The right angle connector you will need is also linked below.

iFlight 90 Degree angle USB connector
https://www.amazon.com/dp/B07RM5DX1V/ref=cm_sw_r_cp_api_glt_fabc_624GDH7GT61MMF9QFXAV

PRINTING:
All