Thingiverse
Single Cable Holder
von pecs1
0
Downloads
0
Likes
0
Makes
Simple Single Cable holder for cables with diameters of 7 and 8 mm. If you want to modify the diameter, simply keep the relation between the measures and use the Part file.
A double-sided adhesive tape is required to stick it on the surface below.
If you are going to print more units of a single unit, it is advisable to print with this parameters:
Layer Height: 0,16
Initial Layer Height: 0,12
Infill Density: 20% (4 mm and Grid)
Retraction Speed: 30 mm/s
Retraction Distance: 5 mm
A double-sided adhesive tape is required to stick it on the surface below.
If you are going to print more units of a single unit, it is advisable to print with this parameters:
Layer Height: 0,16
Initial Layer Height: 0,12
Infill Density: 20% (4 mm and Grid)
Retraction Speed: 30 mm/s
Retraction Distance: 5 mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
