Thingiverse
Single Chamber Whistling Arrowhead
door yrwalrm
32
Downloads
36
Likes
0
Makes
Thick enough to be printed with a 0.6mm nozzle, this is for 8mm arrow shafts. The fit is a little loose, but you can tighten it up by sticking something on the arrow shaft (tape)
Can be printed with zero infill - I printed at 0.3mm.
Arachne turned on in prusaslicer
PETG - roughly 7 grams
Shot with a low power Genesis Compound Bow
Roughly 100 mph
v1.4 is two hole, but still single chamber. This one works best.
Can be printed with zero infill - I printed at 0.3mm.
Arachne turned on in prusaslicer
PETG - roughly 7 grams
Shot with a low power Genesis Compound Bow
Roughly 100 mph
v1.4 is two hole, but still single chamber. This one works best.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!