Thingiverse
Single Dinky Dip Holder
por LieutenantLuLz
0
Descargas
2
Likes
0
Makes
Simple print to hold a single screw top dinky dip from John Neal Books (https://www.johnnealbooks.com/product/screw-top-dinky-dip-refills?searchid=0)
Has an octagonal base so that you should be able to unscrew the lid while the dinky dip is actually inside the holder.
Top configuration is vertical, side configuration is at a 60 degree angle (30 degrees from vertical) to allow for easier nib dipping
Printed in PLA on a Bambu A1 Mini
10% Infill, 0.16mm Layer Height, 3 Wall Loops, Tri-Hexagon Sparse Infill pattern - you can probably use other infill patterns
Rotated in slicer so that the seam was back aligned for a cleaner look
~26 minute print
Has an octagonal base so that you should be able to unscrew the lid while the dinky dip is actually inside the holder.
Top configuration is vertical, side configuration is at a 60 degree angle (30 degrees from vertical) to allow for easier nib dipping
Printed in PLA on a Bambu A1 Mini
10% Infill, 0.16mm Layer Height, 3 Wall Loops, Tri-Hexagon Sparse Infill pattern - you can probably use other infill patterns
Rotated in slicer so that the seam was back aligned for a cleaner look
~26 minute print
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
