Thingiverse
Single extruder Makerbot replicator leveling post
von wdelarme
3
Downloads
1
Likes
0
Makes
This levels the top piece of the extruder so it doesnt hang down on the one side. I added a nylon washer next to the heated block and the post.
Not sure if it was supposed to come with some thing similar from makerbot but mine looked like crap until I put these on
Not sure if it was supposed to come with some thing similar from makerbot but mine looked like crap until I put these on
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
