Single layer test square 100x100
von Filament_Ivanych
16
Downloads
12
Likes
1
Makes
Square 100x100x0.1mm with 2mm sides is for a simple bed leveling test.
Some pros and cons:
+: minimal printing time and plastic consumption
+: you can check leveling of all 4 bed corners
-: you can't be shure that middle point of bed is ok
Please note that layer height can be too low for your slicer software. Just scale Z size to 200% in that case.
Some pros and cons:
+: minimal printing time and plastic consumption
+: you can check leveling of all 4 bed corners
-: you can't be shure that middle point of bed is ok
Please note that layer height can be too low for your slicer software. Just scale Z size to 200% in that case.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
