Thingiverse
Single Rocker Switch Box (Modified For No Support)
door DCayabyab93
1.5k
Downloads
1.2k
Likes
1
Makes
I was searching for a rocker switch mount so I could place a rocker switch underneath the one of the 2040 extrusions of my CR-10S for an LED strip that I'm installing.
I found this nice remix of a rocker switch mount from jagster1991 that suited my needs very well, but I wanted to make sure that it would print nicely without supports needed. All I did was load the file into Tinkercad, and chop off the small overhang on the back side of the switch mount so I could comfortably print it without supports.
The dimensions of the switch I am using for these is 20 x 14 x 25mm ( 0.78” x 0.55” x 0.98”).
I found this nice remix of a rocker switch mount from jagster1991 that suited my needs very well, but I wanted to make sure that it would print nicely without supports needed. All I did was load the file into Tinkercad, and chop off the small overhang on the back side of the switch mount so I could comfortably print it without supports.
The dimensions of the switch I am using for these is 20 x 14 x 25mm ( 0.78” x 0.55” x 0.98”).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
