Single Screw Wall Mount Spool Holder

Single Screw Wall Mount Spool Holder

I have a Ender-3 V3 CoreXZ with a side spool holder which often gets tangled especially when the spool is full. There was a convenient located stud directly above my printer so I whipped this up in fusion 360. It uses a single 150mm screw which also makes it very strong and unlikely to ever break and fall off the wall hopefully. I have used a similar technique to hold up 10-20kg without any issues.

I printed with 7 top/bottom layers and 5 walls that used a bit under 70grams of filament with the tree supports slices in orca.

See pic for the screws I used.