Thingiverse

Single servo Twin arms

von Stuka87

920 Downloads

844 Likes

0 Makes

Zum Modell

I designed this to be used for retractable landing gear but will work for any application you want to use it in. It fits on most if not all 9g servos. All parts are printed flat with no support needed.

Printing:

Temp: 200-210 degrees for layer strength
Layer Hight: .15mm to improve layer adhesion
Infill: 100%

geared servo servo Servo Arm twin servo twin servo arms two arms two servo arms geared servo servo Servo Arm twin servo twin servo arms two arms two servo arms geared servo servo Servo Arm twin servo twin servo arms two arms two servo arms

Quelle

Thingiverse

Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz

Einteilig

Supports 1/3

Zusammenbau 0/3

Einstellungen 1/3

Druckbett 0/3

Nachbearbeitung 0/3

Drucker

FDM / FFF

Dateiformat

STL

Material

Software

Cura, PrusaSlicer o. Ä.

Noch keine Bewertungen

Noch keine Kommentare – sei der Erste!

Single servo Twin arms

Ähnliche Modelle

Zur Sammlung hinzufügen