Thingiverse
Sink Brush Holder
door Thephelpsshop
6
Downloads
3
Likes
0
Makes
Sink brush holder that I designed for my kitchen sink to stop us losing the brushes under all the dishes. It's around 7 inches tall and has drainage holes out the bottom to let water run back in to the sink. There are also some keyholes in the back if you want to use a suction cup.
The picture shows the 8 inch model though if I were to print it again I would probably save some filament and go with the 7 inch model. The extra inch was totally not necessary.
The picture shows the 8 inch model though if I were to print it again I would probably save some filament and go with the 7 inch model. The extra inch was totally not necessary.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
