Sink caddy

Sink caddy to contain sponges or brillio pads and allows airing so that sponge does not stink. This is for the sinks with middle dividers. Dividers should have width of close to 1 inch for it to fit over. If you need wider one, please let me know. It is 1.5 inches deep and 3 inches wide and 2 inches high. 4th revision adds nubs to tilt it so that water does not stand around. And added thicker link to baskets so that it will not break easily.

2nd version is for sinks that have .75 inch lip to hang off of. This one needs to be printed with a raft base and positioned so that one end is on the bed.

Best to print in Standard or higher mode as lower quality cause print problems.

Use PLA Plus for extra rigidity. Temperature 210 and plate temperature 55