Sink drain strainer with PLUG

Sink strainer for the kitchen drain. This works perfectly on IKEA's 80mm diameter drain and probably several other brands. Also created a waterproof plug that can be set in two positions, closed or open. Made this as a test when both of mine broke and I was too stingy to buy new ones. I didn't think it would hold tight but to my surprise it held just fine. If you still have the old stainless steel strainer, fit the plug on it. There is a picture of that version too. The hole in the strainera and plug for the screw is pressfit so be gentle. Things to consider before you print! -Start by printing the plug to make sure it fits and is leak-proof. Since I have only tested it against an older version of IKEA's drain, I don't know if it works as well against others. -The plug must be printed in TPU otherwise it will not be waterproof and it sits really hard. -I printed out the ABS drain strainer and it holds up well to boiling water, etc. I also think PETG works well, but I haven't tested it.