MakerWorld
Sculptures
Model downloaden
Sinking Boat paint No support
2.5k
Downloads
1.3k
Likes
1.1k
Makes
Hi, here a little model of a sinking boatIt print flat with no supports,If the slicer says it need supports, Ignore that it need supports. When its printed, draw imaginaire dot lines on the benchy paint.Its between these right dotlines you need to heat with a lighter underneath, back and forth until the temperature is just above 65 degrees. Boost MePLEASE IF YOU LIKE IT GIVE ME A BOOST Now you can fold it over and push on it to a corner of a table or shelf. When it is cool down, you can heat between the other imaginary dot lines. And repeat the previous steps If you have any problem , let me know Look also my cube painthttps://makerworld.com/nl/models/55104#profileId
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
