Thingiverse
SIO2SD v1.0 Bottom
door jmccorm
12
Downloads
9
Likes
0
Makes
This thing was made with Tinkercad. Edit it online https://tinkercad.com/things/giLVaThF7DI
Recommended plastic: PLA for strength. (Be careful about the usual warping at the bottom layers.)
The tolerances are very tight and the case is held together (amazingly well) just by friction. It may take a little finesse when placing the SIO2PC PCB inside of the main case. Of course, if your PCB is a little bit different, you may need to make adjustments.
I had a great deal of trouble getting the buttons to print properly on my printer (I'm still new at 3D printing) so I made the buttons off-center so that they could be printed horizontally and without supports. There is a little too much wiggle-room which may allow them to get slightly out of alignment. This is my only real disappointment. There is an opportunity here for someone to enhance the buttons (or add more of a guide into the case top in order to prevent wiggling).
When printing the main case, you'll want to enable your pr
Recommended plastic: PLA for strength. (Be careful about the usual warping at the bottom layers.)
The tolerances are very tight and the case is held together (amazingly well) just by friction. It may take a little finesse when placing the SIO2PC PCB inside of the main case. Of course, if your PCB is a little bit different, you may need to make adjustments.
I had a great deal of trouble getting the buttons to print properly on my printer (I'm still new at 3D printing) so I made the buttons off-center so that they could be printed horizontally and without supports. There is a little too much wiggle-room which may allow them to get slightly out of alignment. This is my only real disappointment. There is an opportunity here for someone to enhance the buttons (or add more of a guide into the case top in order to prevent wiggling).
When printing the main case, you'll want to enable your pr
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
