Thingiverse
Sista Stroller Cup Holder Bracket
door Mr0range
1
Downloads
0
Likes
0
Makes
1st Upload.
The original Cup Holder Bracket broke after a while and I could not locate a replacement without purchasing a new Cup Holder. Few prototypes later...… Not perfect but sits really tight and lasted for a while so far. Printed in PLA .4mm lines and with .2mm Layer Height. I went with 85%infill and printed it on the side with supports under the cup-holding-square.
The original Cup Holder Bracket broke after a while and I could not locate a replacement without purchasing a new Cup Holder. Few prototypes later...… Not perfect but sits really tight and lasted for a while so far. Printed in PLA .4mm lines and with .2mm Layer Height. I went with 85%infill and printed it on the side with supports under the cup-holding-square.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!