Skadis Cactus - Small

Cactus Panels with mounting pegs, compatible with Ikea Skadis pegboard. Cactus is apx 245 mm x 110 mm. But the cactus and pot are separate and each measure about 110mm x 100mm, so each piece can print separately on an A1-Mini. I also included a version with screw holes and standoff pegs for wall mounting. Would make a cute earring holder or whatever. Pegs: Included are long and short mounting pegs. Long pegs may be used to offset the printed panel from your Skadis, allowing other attachments to still be used. Short pegs hold the printed panel closer to the Skadis, and may not allow other items to be hung from the panel. Due to the variability in Skadis holes, and 3d printing in general, you may wish to print a few extra pegs. Sometimes one (side) will be too tight for either the Skadis or the printed panel. I use pliers to push in and remove the pegs when needed. Using the PEI Hot Plate, and no glue, pegs stick fine to the plate. But you will need a brim and supports on the pegs if usi