Skadis Ivar conector

This is my solution to a unusual space saving arrangement.
I have set up an Ivar shelf unit on top of a custom bench top with legs, this serves as a compact computer desk and provides extra storage.
I wanted a peg board on the side of the Ivar unit but i could not find a bracket that would fit my use case on thingverse, so i made it.

The Ivar unit I'm using is 50cm deep and the Skadis pegboard i bought was 56 cm x 56 cm and i had to cut it down to fit.

Its important to note that the bracket is not as wide as the upright on propose so it can hold the Pegboard off centre and not interfere with the horizontal beam on the Ivar upright. My first prototype was wider and symmetrical with two screw holes and i had to sand it down 5mm on one side to make it work, the file here has been reworked to just work.

I hope this helps someone, please leave a comment if you print this!