Skadis Lamp Holder

Introduction:This desk lamp holder is specifically designed for THIS lamp. (Measurements of the inside pocket are 30 x 20 mm with R10 mm).Since I didn't think of leaving enough space for a clamp at the back of my desk riser (see picture below) and because of the convenience of having an Ikea Skadis board right behind my PC, I made this holder for myself. But in the unlikely event of someone having the same problem, I thought I'd share my design. Printing:I printed both the base- and the top holder with Bambu Basic PLA.The only settings I changed from the basic A1 0.02mm Standard BBL presets were the following:Wall Loops = 6Infill Pattern = RectilinearSupport = Normal (auto) Installation:Remove the support (obviously)Check if both parts fit in the pegboardSlide the top part onto the lamp (make sure it faces the right way)Slide the base part onto the lampInstall the top part into the pegboardInstall the base part into the pegboard (make sure the cable doesn't get stuck)Connec