Thingiverse
Skadis-Pax mount
von sparlez
7
Downloads
3
Likes
0
Makes
Took the idea from Lvira's design:
https://www.thingiverse.com/thing:4878748
This design is to put the skadis board on the back part of a pax. The Skadis board needs to be cut at the sides (in my case 26mm).
For the nuts you will need 4mm screws.
https://www.thingiverse.com/thing:4878748
This design is to put the skadis board on the back part of a pax. The Skadis board needs to be cut at the sides (in my case 26mm).
For the nuts you will need 4mm screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!