Skadis Plier Mount

Simple plier mount for Skadis. 1U = 1 unit = space between two holes. The printed item in picture is 3U. You may customize the following properties in MakerLab:Additional spacing from pegboard (add to existing 30mm)Plier bar widthPlier bar thicknessRounded edge----- Note:The parts are made for a tight fit – 5.00 mm holes and 4.95 mm inserts. Your printer settings may make them a little too tight or too loose. If needed, you can sand the inserts a bit or use some glue to hold them together. ----- Change log:2025-09-04Added chamfer to one side of the horizontal bar so pliers with spring mechanisms are more stable.You may assemble with the chamfered side or the flat side up, depending on your use case. 2025-09-01Added a new 4U print profile with thicker horizontal bar.Helps preventing bar bending due to the extra length.Bar thickness: 10 → 15mm; Top/bottom surface thickness: 0.76 → 1.32mm.Adds 5 minutes print time.2025-08-26Removed extraneous models in 4U print profile.Sides now have same