Skadis Wire Mesh Mount

This mount fits any type of welded wire mesh with a diameter between 2.0 and 6.0 mm, making it easy to attach any IKEA Skadis board.Installation InstructionsTo install this mount, you’ll need self-tapping M4 screws (one per mount) and either the countersunk rosette included with this wall mount or a suitable washer.The screw should be 30–35 mm long, depending on the thickness of your wire mesh. Longer screws will also work but may protrude from the back—be especially careful if the rear side is accessible or exposed.Attach the MountClip the mount onto the wire mesh at your desired position.Make sure the side marked “Front” faces the Skadis board.Insert the ScrewsInsert your screw (with washer or rosette) through one of the holes in the Skadis board and into the hole in the mount.Align Before TighteningDon’t fully tighten the screws right away. Leave them slightly loose to allow for final positioning of all mounts.Final TighteningOnce everything is aligned, tighten all screws just enoug