Thingiverse
Skateboard Holder
von Stangviertel
9
Downloads
4
Likes
0
Makes
I needed a place to put my skateboard and decided to design an easy to print holder for it. No supports needed. Brim/Raft are optional. 25-100% infill. This can be attached to any shelf, window, ledge, etc. I used it on a window ledge. Enjoy!
Installation Notes: Attach to desired surface with 4 small screws. (Screw hole is 4mm ID)
Installation Notes: Attach to desired surface with 4 small screws. (Screw hole is 4mm ID)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
