Thingiverse
Skateboard Tail Puck
door ThelMightylThor
6
Downloads
4
Likes
0
Makes
Hardware:
2 - m4x20 bolts
2 - m4 nuts
To get the puck to match the curve of the board, after printing I heated the bed to 100 degrees celsius and then let the puck heat up. After it was nice and hot I pressed the puck against the board until it had formed the curve needed to match the board.
2 - m4x20 bolts
2 - m4 nuts
To get the puck to match the curve of the board, after printing I heated the bed to 100 degrees celsius and then let the puck heat up. After it was nice and hot I pressed the puck against the board until it had formed the curve needed to match the board.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!