Thingiverse
Skateboard Wall Mount
von Davieb213
25
Downloads
26
Likes
1
Makes
Redesign of Nickk1997 skateboard holder,
Made slightly wider and curved the inside of the clips to better grip the rounded edge of the board. Made the fixing holes smaller to suit 3.5mm countersunk screws.
Made slightly wider and curved the inside of the clips to better grip the rounded edge of the board. Made the fixing holes smaller to suit 3.5mm countersunk screws.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
