Skeleton Spool – Fast Refill System

Fast printing, multi-hub refill system!

- Compatible with Bambu Lab & equivalent refill spools.
- Two diameters - 175mm and 200mm
- Four hubs for use with internal and external AMSes, arms/hangers, and M8 rod (old skool)
- Print fully featured refill spools better, faster, cheaper.
- Outside diameter 200mm or 175mm, width 67mm, with a hub diameter of 55mm.

NOTES
- Requires six M4x20mm cap-screws and nuts.
- Uses AA batteries for ballast to stop near-empty spools jumping in AMS.
- The locator superglues into one of the rims.
- Do not store in vacuum bag because it will probably deform.
- If using filament dryer, print spool from a material with a higher temperature rating than the refill.


For a more conventional refill spool, visit: https://www.thingiverse.com/thing:6896875



Check out more printer accessories from Department_Nine!



Bambu and Bambu Lab are the trademarks or registered trademarks of their respective holders. No relationship exists or is implied between Department