Thingiverse
Ski boots protector
von ILYAMII
1
Downloads
0
Likes
0
Makes
The metal rod on ski boots can be damaged when walking without skis. This protection is designed to avoid this damage.
For my Fischer boots (NNN, metal rod width 30 mm) - I created version v11.
Also, I created the alternative variant - Fischer NNN, metal rod width 30 mm, with bevels - version v12.
TPU material (soft)
Infill 70%
5 layers of the perimeter.
Important note. The choice between version 11 and 12 depends on the shape of the groove in which the rod is located. 11 version for straight groove. 12 version of the groove in the shape of a trapezoid.
If you do not know your groove shape and cannot measure it, then printing version 12 is your best choice.
For my Fischer boots (NNN, metal rod width 30 mm) - I created version v11.
Also, I created the alternative variant - Fischer NNN, metal rod width 30 mm, with bevels - version v12.
TPU material (soft)
Infill 70%
5 layers of the perimeter.
Important note. The choice between version 11 and 12 depends on the shape of the groove in which the rod is located. 11 version for straight groove. 12 version of the groove in the shape of a trapezoid.
If you do not know your groove shape and cannot measure it, then printing version 12 is your best choice.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!