Skinny TUSH++

- The original 3mm walls of the TUSH (The Ultimate Spool Holder) were way too thick to fit inside of the [generic cereal boxes](https://www.amazon.com/dp/B08TWH2QHV) I had while using a 68mm wide Bambu spool.
- The walls in this remix are 1.4mm, with added reinforcement along the bottom to keep it strong despite the thin walls.
- It's compatible with [TUSH++ rails](https://www.thingiverse.com/thing:2451368). Since the walls are thinner, it wobbles a little bit on the rails. If this is a problem, the wedges can be used for extra support.

# Instructions

- All items can be printed without supports.
- I used a 0.4mm nozzle with 0.2mm layer height on a Bambu P1S.
- Assemble using 4x [608 ball bearings](https://www.amazon.com/uxcell-Groove-Bearing-Double-Bearings/dp/B07FF1RBPV) that snap into the pegs.
- The .f3d file is included if you need to change the thickness or if the bearing pegs need to be modified for your printer.