Thingiverse
Skippy the Magnificent
von thepadretemplar
20
Downloads
20
Likes
1
Makes
Trust the awesomeness!
Listen up dum dum. Shmaby, just shmaby, one of you meat sacks can get this to come out right.
My first attempt was a disaster. pimples all over, delams, ugh. not good. and when i sanded it becaue it only had 2 walls, the heat from the sanding caused bubbles... terrible. just terrible. Stupid monkey.
Anyway, this one is better. Thanks to the Creaawesome mod for Cura.
To get Skippy to be 6.5 inches tall and 3.5 inches wide you'll need to increase the percentages as I listed below. Otherwise he'll come out about 5 inches tall and 2.5 wide.
Good luck you stupid monkeys.
Listen up dum dum. Shmaby, just shmaby, one of you meat sacks can get this to come out right.
My first attempt was a disaster. pimples all over, delams, ugh. not good. and when i sanded it becaue it only had 2 walls, the heat from the sanding caused bubbles... terrible. just terrible. Stupid monkey.
Anyway, this one is better. Thanks to the Creaawesome mod for Cura.
To get Skippy to be 6.5 inches tall and 3.5 inches wide you'll need to increase the percentages as I listed below. Otherwise he'll come out about 5 inches tall and 2.5 wide.
Good luck you stupid monkeys.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!