SKR 1.3 AM8 Case

This is a case for the SKR 1.3 and Raspberry Pi that is designed to be mounted on the AM8.

It's inspired by this case, but designed from scratch and is substantially different, so was not posted as a remix:

https://www.thingiverse.com/thing:3732733

The case is designed so you can run your Z-motor, Y-motor, and heat bed wires through the extrusions and then have them exit inside the box for a super clean wiring setup. You'll need to drill some small holes in the extrusions (and deburr them!) to run the wires through the framing.

Supports are only required on the main case to support the overhanging notch for the extrusion bracket.

The MOSFET on the SKR is a good MOSFET, so I did not add space for an external MOSFET as there is no reason to do that with this board.

There is a cable gland on the top of the box for your X-carriage and Y-carriage wires to exit and be held in place.

Ziptie mounting points are located near the connectors for the wires going to the moto