Thingiverse
SKRPI Case
by jmcconn110
0
Downloads
0
Likes
0
Makes
Case to house a SKR v1.4 Turbo and RaspberryPI 3 (OctoPI)
Designed to print on 200x200 bed, I had to expand one axis to 205 in my firmware to get it to print right since the length is exactly 200mm
Intended for use on a MonoPrice Maker Select V2 with an 80mm fan but could work for any printer with minimal modification.
Provisions for HiLetGo DC-DC USB Buck Module to power the RasperryPI with 24V from the printers power supply.
Provisions for Zipties on the base, match with the right side of the IIIP frame.
I used leftover hardware from the IIIP controller box and leftover coarse threaded hardware from PC case
Printed with PETG 0.2mm layer thickness 100% infill
Designed to print on 200x200 bed, I had to expand one axis to 205 in my firmware to get it to print right since the length is exactly 200mm
Intended for use on a MonoPrice Maker Select V2 with an 80mm fan but could work for any printer with minimal modification.
Provisions for HiLetGo DC-DC USB Buck Module to power the RasperryPI with 24V from the printers power supply.
Provisions for Zipties on the base, match with the right side of the IIIP frame.
I used leftover hardware from the IIIP controller box and leftover coarse threaded hardware from PC case
Printed with PETG 0.2mm layer thickness 100% infill
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!