Thingiverse
SKULL - CURSED
by bugman_140
140
Downloads
109
Likes
0
Makes
Here is the Skull that I made in Sculptris for Halloween.
I printed mine in Fillamentum Vertigo Starlight, but i'm looking forward to trying it in some more colour choices,
The bottom of the model has a shaped underside to allow it to be used in more situations, Though I was planning to sit mine on a table so I sank the model into the print bed to make it more stable (it also meant less supports were required).
I hope you enjoy and Happy Halloween
I printed mine in Fillamentum Vertigo Starlight, but i'm looking forward to trying it in some more colour choices,
The bottom of the model has a shaped underside to allow it to be used in more situations, Though I was planning to sit mine on a table so I sank the model into the print bed to make it more stable (it also meant less supports were required).
I hope you enjoy and Happy Halloween
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
