Skull Extruder Button

Decided to make an extruder button because I was tired of pushing my thumb down on that annoying allen cap screw whenever I needed to change filament.
Walked through Thingiverse to see what was posted and nothing really struck me as a decent looking button. They were all just fine for their intended purpose and all but I'm somewhat anal retentive and wanted to stay with the general theme I had started so far.

I was in the air about supports as it is fairly small anyway and messed up overhangs wouldn't be too noticeable but went with them anyway. I was pleasantly surprised to find that they came away rather cleanly and the piece came away looking not entirely bad at all. The supports up the center even pulled right out as I lifted it from the bed.
I used a skirt but I don't think that was even necessary. Use what you will.

**Total print time: 50:14**
**Filament used: 1.17 m **