Thingiverse
Skull LED Lamp
door Mike-vom-Mars
1.2k
Downloads
965
Likes
7
Makes
Skull LED Light
Hollow human skull with a hole (diameter 66.8mm) at the bottom to put a LED light through. I used the LEDs and battery holders from LED candles (similar to these: http://ebay.to/2tZLjF1 ), so the lamp can be set to different colors via a small remote control.
https://youtu.be/mYJU_s6F5hc
Printing:
- No supports needed
- No infill
- Use transparent PLA
- Wall thickness 0.8mm
- Layer height 0.3mm (or less)
- Use raft for good adhesion
Hollow human skull with a hole (diameter 66.8mm) at the bottom to put a LED light through. I used the LEDs and battery holders from LED candles (similar to these: http://ebay.to/2tZLjF1 ), so the lamp can be set to different colors via a small remote control.
https://youtu.be/mYJU_s6F5hc
Printing:
- No supports needed
- No infill
- Use transparent PLA
- Wall thickness 0.8mm
- Layer height 0.3mm (or less)
- Use raft for good adhesion
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
