Thingiverse
skullcrown
von CLEAPSS
37
Downloads
59
Likes
0
Makes
This is a combination of a skull and a crown. Used for Halloween decoration.
Mixed in 3D Builder
Sliced in Repetier
Printed on a Kora midi.
Bed 50C
Hot end 220C
PLA
20% infill
Supports all over
about 10 hours
Mixed in 3D Builder
Sliced in Repetier
Printed on a Kora midi.
Bed 50C
Hot end 220C
PLA
20% infill
Supports all over
about 10 hours
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!