Thingiverse
Sky-Watcher flextube 250p
von erwinha
10
Downloads
3
Likes
0
Makes
I rounded the edges of the board. Also, since the print is able to move down when placed in the original eyepiece holder I added a block so it rests against the telescope mount.
It would have been even better maybe to broaden the board and added an "L-shape" on the outer edges which rest again the telescope mount, but since the was already a long print I did not do this,
It would have been even better maybe to broaden the board and added an "L-shape" on the outer edges which rest again the telescope mount, but since the was already a long print I did not do this,
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
