Skycontroller ON/OFF Switch (for Bebop Drone)

Fell and lost it the first day....

4 iterations to get that.

Slicer:
As always, check the output of your slicer.

Print
Print with supports. See picture for the orientation.
About 20..24mn.


Installation :
NOTICE the asymmetry of the part.
Pay attention to the current position of the black pin of the switch (in the skycontroller) and align with it.
Insertion requires some strong force AND care.
Press on the peg or very close to it only.
Else you may break the edges if you have poor layer adhesion.

But then won't fall out. And still fits in the box.

PETG may be better than PLA for that.